User guide

5-4 Encore Multi-port DSU/CSU User GuideÑJuly, 1997
5
Changing Information
Most of the menus are toggles: pressing either the up or down arrow key changes the
parameter from Yes to No, or Disabled to Enabled, or some other setting according to
that parameter features. (Refer to Chapter 3 for descriptions of individual parameters.)
In the CONFIGURATION menu, you can modify the information.
For example, to change the UNIT ID (at the beginning, EFS 100 PERCENT):
1. Press ENTER.
The menu you see is CONFIGURATION.
2. Press ENTER.
The menu you see is UNIT CONFIG.
3. Press the Down arrow key.
The menu you see it UNIT ID.
4. Press the ENTER key.
In edit mode the Þrst LED character blinks showing that it is ready for your
change.
5. Press the Down key.
The Þrst LED character changes. Each time you press the Down key, an
alphabet character is shown. At the end of the alphabet, as you continue to
press the down key, you Þnd the 0 through 9 numerals.
In Edit mode, the up or down keys give access to: A, B, C, D, E, F, G, H, I, J,
K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z, 0, 1, 2, 3, 4, 5, 6, 7, 8, 9.
When you decide which character to use, press the ENTER key. The Þrst
LED character key is locked, and the second ßashes to show its readiness for
your change.
These steps apply to all parts of the CONFIGURATION menus. For the other menus,
choosing either the Up or Down key changes the parameter or test setting.