Service manual

96 Encore — Configuration Manual
Section 4 — Initial Encore System Setup
Configure the Router Control Application:
1. Select Config.
2. Select Area and answer Yes to the warning message.
3. Select the desired Area (e.g. “StudioA”).
4. If you want the name of the Area (not just the number) to be visible to
the CP Server application, use the Change Area Alias button to enter
the name.
5. Select Save and answer Yes to warning message. If this is a redundant
SCB installation, also answer
Yes to update the mirror with changes.
6. Select Commit Changes.
7. Repeat this process for each Router Control application.
Configuring Control Panels in Areas
See Control Panels and Areas on page 275 for specific instructions.
Changing Area Assignments
• To assign a Router Controller to a different Area, use the Router Control
application as described above (
Assigning a Router Controller to an Area
on page 95).
• To give a control panel access to a different Area, use the Control Panel
Server application as described above (
Configuring Control Panels for
Specific Area(s) on page 276).
Note It isn’t necessary to return to the System Manager application to change the
Area assignment of the SCB or Router Control application.