Service manual

82 Encore — Configuration Manual
Section 4 — Initial Encore System Setup
19. Repeat Step 12 through Step 18, substituting the executable,
application, and display names for each of your remaining applications
as indicated in
Table 5.
20. When you’re done adding applications, remember to click the Save
button, then click the
Main Menu button on the Menu Bar to return to the
Main window in System Manager.
Adding Engines
Once you’ve registered the application(s) you want to run somewhere in
the Encore environment, you must identify the engine(s), host(s), or
server(s) which will run those applications. For example, an Encore System
Controller always runs the Control Panel Server application, but it is fre
-
quently also the engine running the Tie-Line Manager applications. The
Sharer PC is always the engine running the System Manager application,
but other applications may run on it as well. Remember, however, that
Encore’s system architecture allows you to distribute applications among
multiple engines to balance the load.
Follow these steps to add engines.
Note Before you proceed, you’ll need to know the IP address of the engine(s) you
want to add.
21. From System Manager click the Engines button on the Main Menu. The
Engines window appears (
Figure 56).
Table 5. Software Executable, Application, and Display Names
Full Name
User Can’t Change User Can Change With System Manager
EXE Name Application Name Display Name
Control Panel Server !APP_CPServer Control Panel Server CP Svr
System Manager !APP_Man3 System Manager Mgr Svc
Tie-Line Management !APP_TLM Tie-Line Manager TLM