Service manual

68 Encore — Configuration Manual
Section 4 — Initial Encore System Setup
Note When the Sharer Watchdog program is launched it detects whether a Sharer
is already running on the network, and if found terminates the launch with the
message Sharer is already running on the network at IP ADDRESS.
Note Always launch the Sharer with the Watchdog application, not directly, to
ensure the Quick CPS Salvo Startup feature is active (see
page 213).
2. Run the System Manager application by clicking its icon on the desktop
(
Figure 40). After the application launches you can minimize (but do
not close) the System Manager window.
Figure 40. System Manager Application Window
3. The Windows task bar should now indicate all the open applications.
Figure 41. System Manager Application Window
4. Now reset both SCBs by pushing the reset button of each controller.
This will make each SCB acquire its default configuration from the
Sharer running on the PC. All the control panels will also be sent
default configurations.
Figure 42. System Manager Application Window
SCB Reset Buttons
(on top of board below handle)
8531_07r0