Service manual

66 Encore — Configuration Manual
Section 4 — Initial Encore System Setup
4. Click OK, then click on Apply Changes. The device resets and the new IP
address will then be reported in the left pane of the NetConfig screen.
Note To identify a specific remote panel when several are connected, right-click on
the panel in the NetConfig hierarchy display and choose Identify Device. That
panel’s buttons will flash.
Specify System Controller Applications
Each Encore System Controller needs to also be configured on its web page
to load the applications it will be using. For this initial setup, the System
Controllers need to be configured to load and run the Panel Server and
Router Control applications. These may already be set at the factory but
you should check these settings.
Slot 1 (Left) SCB
1. Find and double-click the System Controller in the left pane of the
NetConfig window with IP 192.168.0.100.
2. When the home page for the device opens in the right pane of the
NetConfig window, click the
Application Configuration link.
3. When the Application Configuration page opens, confirm that the
Panel Server application and Router Engine boxes are checked
(
Figure 39).