Service manual

Encore — Configuration Manual 57
Initial Setup Using Default Database
Create Default Encore Network
Default IP Addresses
Sharer PC
Encore system components ship with default IP addresses. To use these
default settings, the PC you use to configure your Encore system will also
run the Sharer and need to have the following settings:
Your Sharer PC will also need the following settings if you are using it on
an isolated network:
• Ensure MS Firewall turned off.
• Internet Explorer is configured correctly, and
• Internet Explorer proxy server must be disabled.
Encore System Controllers
An Encore System Controller ships with the following default IP addresses,
and these addresses are included in the Encore default database:
Table 2. Sharer PC IP Addresses
Encore Sharer PC
Ethernet IP Address 192.168.0.102
Ethernet Subnet Mask 255.255.255.0
Ethernet Gateway 192.168.0.100
a
a
PC Ethernet Gateway must match Encore Master Controller Ethernet1 IP Address
Table 3. Encore System Controller (SCB) Default IP Addresses
Encore Controller 1 (master) Encore Controller 2 (mirror)
System Name SCB-1A SCB-1B
Ethernet1 IP Address 192.168.0.100 192.168.0.101
Ethernet1 Subnet Mask 255.255.255.0 255.255.255.0
Ethernet1 Gateway N/A N/A
Ethernet2 IP Address 192.168.1.1
a
a
Ethernet2 IP Address must match Ethernet2 Gateway address for that Encore Controller.
192.168.1.2
a
Ethernet2 Subnet Mask 255.255.255.0 255.255.255.0
Ethernet2 Gateway 192.168.1.1
a
192.168.1.2
a