Service manual

Encore — Configuration Manual 367
Local Machine Control Panel (LMCP)
Scanning the tape causes the following window to appear.
Figure 222. Typical Information Read From Barcode Window
The top area of this window is identical to the Register Tape window in
both appearance and functionality. Relevant information from the barcode
scan is shown on the buttons. The bottom area, labelled Clip details from
barcode, shows the registered clip details (this only applies if the tape is
single segment).
Changing the Clip Details
1. Click the Name button to display the Enter New Clip ID Alphanumeric
Keypad; using this you can change the clip ID.
2. Click the Title button to display the Enter New Clip Title Alphanumeric
Keypad; using this you can change the title.
Exiting the Local Machine Control Panel
You may exit the LMCP at any time by clicking the Eject icon in the top right
corner of the screen.
Memory of the LMCP
When you switch off the OUI workstation, the system saves all of the
LMCP options.