Service manual

362 Encore — Configuration Manual
Section 8 — Additional OUI Operations
Figure 217. Typical Current PDC Type Window
Categorizing Clips
1. Click the Major Category button to display the Select Major Category list
window.
Once the Major Category has been selected, it is shown on the Major Cat-
egory button. The Select Major Category list window is replaced by the
Minor Category list window appropriate to the Major Category
selected.
2. Select the required Minor Category. Once selected, it is shown on the
Minor Category button.
Note If you click the PDC button and there is no PDC information associated with
the clip (this is set using the Options button), the OUI displays a warning
message.
Logos
The Logos button is used to define set points in a clip for the displaying of
Logos or the triggering of General Purpose Interfaces (GPIs). Clicking the
Logos button displays the Select Logos and GPIs window.
Figure 218. Select Logos and GPIs Window
This window shows eight numbered Logo indicator buttons, and eight
numbered
GPI indicator buttons. Each button can be clicked to toggle it on
(indicator shows green) and off (indicator shows black). Each numbered
button represents a pre-configured logo or GPI, which will be assigned to