Service manual

352 Encore — Configuration Manual
Section 8 — Additional OUI Operations
Clicking the Stop button stops the currently selected device; the button
shows white.
The Shuttle Bar provides incremental control of the currently selected device.
Cue Points Area
The Cue Points Area enables you to recall a clip at relevant points within
the clip. The functions of the different buttons are described below.
Using the Cueing Control Buttons
1. Load a clip.
2. Play the clip.
3. Click the Set button so it becomes green.
4. Click one of thee Cueing Control (M1 to M6) buttons to store the time code
of a point in the clip. The
Set indicator button becomes grey. (You can
pause the clip at the point before storing the time code if you want to.)
5. Click the Set button (so it becomes green) and then a Cueing Control
button for each time code you want to store.
6. While the Set button is grey, clicking a Cueing Control button pauses the
clip at the stored time code.
7. Click the Go To button and enter a time code in the Keypad displayed.
The clip pauses at that time code.
8. Click the In button or the Out button to pause the clip at the marked-in
or marked-out point.
Note The Cueing Control buttons store the time codes you allocate to them. The
time codes are not stored with the clip, and are only retained during the LMCP
session in which you define them. They are lost if you overwrite them or if
you switch the OUI workstation off. If you load a new clip, the stored time
codes apply to this also.
Ancillary Area
The buttons in the Ancillary Area are used to access specific functions of the
LMCP application.
Routing
If any devices in the device panel are loaded with the object database and
have their routing information correctly configured, pressing the
Routing