Service manual

Encore — Configuration Manual 349
Local Machine Control Panel (LMCP)
Copying (Dubbing) a Clip to a New Location
1. Add the destination and source devices to the Devices panel and Lock
them.
2. Load a clip onto the source device and set the play flag.
3. Create a clip on the destination device (see Creating a New Clip on a Video
Disk Server on page 346), give the clip an appropriate duration and set
the record flag.
4. Ensure that you route the Source to the correct Destination.
5. Click the Auto Edit button to automatically start the devices. The button
becomes yellow while devices are cueing. The button becomes green
once cueing is complete.
6. When the edit is complete, click the Auto Edit button.
Note You can execute this action by using the Auto Start button. The LMCP always
refers to the currently selected device, even if another user has locked the
device.
Time Base Correction Panel
If the currently selected device is a VTR, click the T.B.C. button (Time Based
Corrector) to display the
T.B.C. window. You can adjust the output Levels of
the signals by using this panel. Click the scroll bar or the arrows on either
side. Move the bar to the right to increase the Level. Move the bar to the left
to decrease it.
Figure 208. Time Base Correction window
Setting Time Base Correction
1. The Preset indicator button shows if the default setting is on (indicator
shows green) or off (indicator shows black) and can be selected for
individual signals. If a signal is using the preset value, changing this
value automatically switches off the preset option.
2. Click the Video button to adjust the output Level of the video signal. This
can be regarded as adjusting the brightness.
3. Click the Chroma button to adjust the output Level of the chrominance
signal. This can be regarded as adjusting the color.