Service manual

Encore — Configuration Manual 347
Local Machine Control Panel (LMCP)
3. Click the Enter/Return button. The clip information appears in the Clip
Area.
Note Step 4 applies only if no device is selected in the Devices panel.
4. When the Select a Device list window appears showing devices that can
load a clip, select one of the devices.
The Select a Device list window disappears. The system adds the device
to the Devices panel and loads the clip.
Note If you select ‘No Device: Clip Data Only’ from the list, a device is not added to
the Devices panel but the clip data is still displayed. You can therefore alter
the clip information rather than the media. Use this method of selecting a clip
if you do not know whether a clip is on a tape or a disk.
Modifying and Saving Clips
1. Click the Mark In button to change the in-point of the clip. The in-point
will be changed to the time code reached at the moment you press the
Mark In button.
2. Click the Mark Out button to change the out-point of the clip. The out-
point will be changed to the time code reached at the moment you press
the
Mark Out button.
3. To rename a clip, click the Clip Name window and enter a new name on
the displayed Keypad.
Note New in-points and out-points are not recorded unless you save the clip.
4. Save the clip by either:
• Clicking the Save button to save over the current clip.
- Or -
• Clicking the Save As button to save a new instance of the clip.
Device Selection and Control
The Device Selection Area consists of an 8-slat panel for selecting and dis-
playing the names of up to eight devices, and two buttons to add or remove
devices to or from the list.
Setting Options
Before you can select options for a device, you must add them to the
Devices panel.