Service manual

340 Encore — Configuration Manual
Section 8 — Additional OUI Operations
Setting up Salvos
1. Click the Salvos button to display the Salvos window.
Figure 205. LRP Salvos Window
2. Click Load Salvo to edit an existing Salvo; Delete Salvo to delete the
currently loaded Salvo; or
Clear Salvo to clear any loaded Salvo and
create a new one.
3. Click the Salvo Keycap button and enter the new Salvo name on the
Keypad displayed. Press the return key when finished.
Note The Salvo keycap name must be identical to the Salvo filename saved in
Step 7 below. The name entered in both locations must be must be 8 charac-
ters or less, not be a duplicate of an existing Salvo, cannot have spaces, and
cannot contain the following special characters:
/ \ ; : , * ? “ < > | ,
4. Click the Dest column and select the Destination required. You may
need to open the folder to see the entire list of Destinations available.
5. Click the Source column and select the Source required. Again, you may
need to open the folder to view all the Sources available or scroll back
to the top of the list window.
6. Click in the Levels column of the Salvos window and select the Level
required from the window displayed.
7. Click the Save Salvo button to save new Salvo.
Note The name of the saved Salvo file must match the keycap name entered in
Step 3 above.