Service manual

Encore — Configuration Manual 339
Local Router Panel (LRP)
2. Click the Under Monitor Display (UMD) below the Global X/Y button to
display the Router Sources list window from which a Source can be
selected. The Source then appears on the UMD. The X/Y routing
remains established until it is changed or until the OUI workstation is
switched off.
Activating LRP Buttons
1. While in Config Mode, click on a grayed out LRP button. An activation
pane will appear.
2. Click on the Enable button to activate or de-activate that button.
To Preview a Route
1. Click the Preview button to toggle it on (button shows green).
2. Click and hold a new Source button to route to the new Source. The
Source button will turn red whilst in preview mode.
3. Release the new Source button to revert to the initial Source.
Note You cannot preview a protected Source. Attempts to do so will cause a
message window to be displayed, informing you that previewing is not pos
-
sible.
Parking a Destination
1. Select the Destination to park.
2. Click the Park button.
The Destination will be parked, and the UMD below will display Parked,
thus freeing the Source without losing the Destination.