Service manual

334 Encore — Configuration Manual
Section 8 — Additional OUI Operations
Different Source banks can be displayed by using the Source Page Navigation
Controls, the number of banks depending on the overall system configura-
tion. These controls are used primarily to find Sources.
Under Monitor Display
Below each Destination button there is an Under Monitor Display (UMD),
which shows the Source currently connected to that particular Destination.
When a Destination is selected, the Source Bank containing that Source is
displayed. Clicking on the UMD opens a window allowing selection of a
Source from the available Areas.
Using the Basic Local Router Panel
Opening the Local Router Panel
Click the Local Router Panel icon on the OUI Task Bar to open the LRP.
Selecting a Destination and Source
If the Destination and Source are displayed on the screen:
1. Click the appropriate Destination button; the button will be highlighted
green.
2. Click the desired Source button,
- Or -
Click the UMD and select a Source from the list window displayed. If
your system has multiple Areas, selecting an Area in the window dis
-
plays the Sources in that Area.
Note Certain Destinations may be configured as being ‘protected’ by the System
Administrator. A warning message window is displayed if you attempt to
route a Source to a protected Destination, and you are required to either
confirm or abort the route.
Finding Destinations and Sources
If the Destination and Source are not currently displayed on the LRP screen,
you can search for them: