Service manual

324 Encore — Configuration Manual
Section 7 — Tie-Line Manager
Clicking on the Name, Ultimate Source, or Local Source columns opens the Tie-
Line Status pane displaying information about that tie-line (
Figure 195).
Figure 195. Tie-Line Status Pane
This same information is displayed on the Tie Config screen (Figure 191 on
page 316), and this pane operate the same. For example, clicking on the
Tie Users button displays a list of all the users of that tie-line.
The In Use By column shows the top user along with the number of users of
that tie-line. An unavailable or offline Router Matrix is also indicated in this
column. Clicking the
In Use By column of a tie-line in use allows you to
release that tie-line. A warning message appears that you must confirm
before the tie-line will be released (
Figure 196).
Figure 196. Release Tie-Line Warning Message .
(Top of Screen) Area Buttons
Displays the names of the current Areas selected. Clicking
on a button opens a list of the Areas for selection. The left
button selects a Source Area, and the right button selects a
Destination Area. Only tie-lines spanning those areas will
be displayed below.
% Usage
Displays the percentage of tie-lines currently in use
between the selected Areas.