Service manual

Encore — Configuration Manual 317
Tie-Line Manager Screen Descriptions
This Tie Config screen is used to configure individual tie-lines.
Select Tie Line
Opens a window allowing you to select a tie-line for config-
uration.
You can also use the left and right arrows to scroll through
the available tie-lines.
Save
Saves the selected tie-line configuration.
Ref. Name
Displays the name of the selected tie-line.
OffLine
When on, the tie-line is taken off line. Typically this is only
used when building a new system to keep operators from
trying to use routes using hardware not yet installed.
If an existing tie-line is taken off line, the Source and Desti-
nation will not change, but the tie-line will not be usable by
any others, and will not be able to be released.
Displays the respective Areas of the Source and the Desti-
nation of the selected tie-line.
Floating
When on, the tie-line will be used whenever it is needed by
the system.
Reserved
When on, the tie-line will be reserved for use by only one
Destination. Clicking on
Type Param opens a window to
select the Destination.
Fixed
When on, the tie-line will be always be use a specific Source
and Destination.
Room
When highlighted, the tie-line is associated with a Room.
Type Param
Displays the qualifier for the selected mode (for example,
the Reserved Destination).
Available
When highlighted, the tie-line is available for use.
In Use
When highlighted the tie-line is being used, and the first
user is listed in the Tie Users box below.
Tie Users
Displays the first user of the tie-line. Clicking on the box
opens a window that lists all the users of that tie-line, and
the date and time they each began using the tie-line.
Ult. Src.
Displays the name of the ultimate Source of the tie-line, if
in use.