Service manual

316 Encore — Configuration Manual
Section 7 — Tie-Line Manager
Tie Config Screen
Figure 191. Tie-Line Manager Tie Config Screen
Find Source
When a Destination is selected, clicking on Find Source will
display the current Source for that Destination in Source
button above.
Dest. Levels
Displays the Levels involved in the selected path.
Find Path
When pressed, searches for a path between the selected
Source and Destination. If found, the tie-lines involved are
displayed on the left.
Make Path
When a valid path has been found, clicking on Make Path
will switch the Source to the Destination using the indi
-
cated tie-line(s)
Max Hops
Sets the maximum number of hops the system will search
to find a path.
CAUTION - To prevent slowing system performance,
select the smallest number of hops to meet your needs.
Build Path
When on (colored green) the tie-line path is built manually.