Service manual

Encore — Configuration Manual 315
Tie-Line Manager Screen Descriptions
Route Screen
Figure 190. Tie-Line Manager Route Screen
The Route Screen is used to set the number of tie-line hops the system will
use, and can also be used to manually create tie-line routes. Because Tie-
Line Manager, once configured, creates and releases tie-lines automatically
as needed, this screen is not routinely used. However, it can be helpful if
you want to test tie-lines to ensure your system topology permits the cre
-
ation of the routes you will need.
Source
Opens a window from which you can select the ultimate
Source of a tie-line.
Displays the tie-lines involved in a found path.
When the Build Path button is green, you can manually select
tie-lines for a path. Click on the bottom empty box to open
a window allowing selection of existing tie-line usable by
that Destination.
Click on a displayed tie-line to see more information about
that tie-line.
Dest.
Opens a window from which you can select the ultimate
Destination of a tie-line.