Service manual

314 Encore — Configuration Manual
Section 7 — Tie-Line Manager
Event Logging
Opens a window allowing selection of logging options.
CAUTION - To prevent slowing system performance,
keep logging disabled unless you are troubleshooting.
Don’t Care Lvls
When ON, allows tie-lines to be established using a tie-
line Source (router Destination) with Levels that don’t
match those of the tie-line Destination (router Source).
When OFF, all Levels of a tie-line must be used. The tie-
line Destination (Router Source) must match all required
Levels of the requested Router Destination. The tie-line
Source (Router Destination) must be on all its Levels by
the requested Router Source. The actual tie-line Destina
-
tion (Router Source) may have more Levels than the tie-
line requires, however. See
Mismatched Tie-Line Work-
arounds (1.7.4 and Earlier Software) on page 310 for more
information.
Enable
Assignments
Activates the Assignments feature (see Tie-Line Manager
Assignments on page 328).
Park Ties on
Release
Each physical matrix may have a Source configured as its
park input. When on, this Source will be selected auto
-
matically when a tie-line is released.
Partner Timeout
Specifies in milliseconds how quickly the partner TLM (if
present) will take control. The default value of 500 is
usually adequate.
NOTE: If the number of multi-hop tie lines in your system
is 200 or more, this value should be set to 1000 millisec
-
onds. This helps prevent the TL status map from going
out of sync due to the latency of multi-hop operations.