Service manual

290 Encore — Configuration Manual
Section 6 — Control Panel Configuration
Figure 183. Router Level Selection for Display Tally
Selecting a level will make that display show the source name of that Level.
More than one Level can be selected, in which case the display you selected
and the displays below it will show Level statuses. For example, clicking on
the second (Status) display, and choosing three Levels from the list will
make the top display continue to report Destination, and the lower three
displays will report the Source names of those three Levels.
Normal JEP-100 panel operation, like scrolling through available Sources,
is still supported. The display will temporarily show the list of Sources
while scrolling, but when done the display will time-out after a short time
and re-display Level tally.