Service manual

Encore — Configuration Manual 287
Available Panel Configuration Screens
JEP-100 Panel
Routing Control System Mode Selection
The JEP-100 panel can be operated with either Encore or Jupiter control sys-
tems. For Encore operation, the proper software must be loaded onto the
panel (older Jupiter only software cannot be used). The
Encore Routing
Control System Mode setting must also be selected on the JEP-100 Panel
Network Configuration web page (
Figure 180). A reset is required to
change operating mode. This can be done by checking the Do Reset box at
the bottom of the web page before clicking the
Save New Settings button.
Figure 180. JEP-100 Panel Network Configuration Web Page
Note Additional steps may be required to convert a JEP-100 panel between Encore
and Jupiter system control. Contact Grass Valley Support for specific infor
-
mation on panel conversion.