Service manual

282 Encore — Configuration Manual
Section 6 — Control Panel Configuration
Pressing the AllLvl/CFG control panel button for 5 seconds puts the panel in
Self configuration mode. In this mode Source/Destination/Salvo/Level
select buttons can be reconfigured for any available Source/Destination/
Salvo/Level using the Level/Previous and Level/Next buttons to scroll
through available items on the control panel.
1. Using the Encore UI, configure a panel button with AllLvl/CFG and two
other panel buttons as
Level/Prev and Level/Next.
2. Press and hold the AllLvl/CFG button for 5 seconds. That button will go
high tally and the panel displays SRC CONFIG.
3. Press a Source, Destination, Salvo, or Level Select button to be configured.
That button will flash, and the panel displays the current selection for
that button.
4. Press the Level/Prev and Level /Next button to browse through the
available items. Leave the desired item displayed on the panel.
5. Press the previously selected Source, Destination, Salvo, or Level Select
button to configure the displayed item for that button.
Only the AllLvl/CFG, Level/Prev, and Level/Next buttons are active in Self Con-
figuration mode. The panel reports NOT USED if any other buttons are
pressed.