Service manual

Encore — Configuration Manual 279
Configuring Encore Control Panels
Joystick Override Configuration
Joystick override permits switching video momentarily to another Source,
and then returning to whatever Source was previously selected. This
feature is typically used for camera matching. The following control panels
support Joystick Override:
Joystick override is configured using the Joystick Override buttons on the
individual panel configuration screens, using the standard practice of
going to Selection mode, clicking on a button and selecting the Source to be
used for override. An example with these Joystick override selection
buttons is shown in
48B (48 Button) on page 285.
Two types of override are available, the default Source Select (non-latching)
and Source Select. The type of override is configured by going to Assignment
mode and selecting the joystick override button to be configured
(
Figure 177).
Figure 177. Source Select Non-Latching Control Panel GPI
Table 26. Joystick Override Panels
Encore panels BPS-GPI, 48B-GPI, JEP-100
SMS panels P32, P48
Kalypso panels KMD, KSD