Service manual

Encore — Configuration Manual 277
Configuring Encore Control Panels
Figure 175. Area Exclusion Set Menu
3. Select the Default Named Set, click Save As and give the new set a
descriptive name.
4. Click all the System Areas you wish to exclude so that their green
indicators are On. You can click
Exclude All or Exclude None to quickly
select or clear multiple Areas as a starting point.
5. When all the Areas to exclude all selected, click Save to save the changes
to the Exclusion Set.
6. Exit the menu. That Area Exclusion set will now be assigned to that
panel. Sources and Destination in the excluded Areas will not appear in
the selection panes used to configure that panel.
7. Configure the panel buttons with the desired Sources and Destinations
in the available Areas.
8. When done with the panel configuration, click Save to save the changes.
Once an Area Exclusion set has been created and defined, it can be used by
any control panel.
CAUTION If an Area Exclusion set in use is edited, all panels using that Exclusion Set
will be affected.