Service manual

Encore — Configuration Manual 261
Configuring Encore Control Panels
XY + 48B Grouping Configuration Example
In an XY+ 48B configuration, the buttons of the 48B panel are treated as 48
extra buttons added to the 18 assignable buttons on the XY panel.
Operational control panel name based messages (e.g. in case of Lock, Pro-
tect, or error messages) will only show the XY panel name.
Figure 162. Example of XY+ 48B Panel Group.
1. Log in to the CP Server application.
2. Configure the XY panel:
a. Go to Encore Panels > XY > Select. Select the XY panel that will be the
Master panel.
b. Go to Configure XY Flags > Panel Group Name. This will display the
“Panel Groups names list.” Select the name of this XY panel.
c. Configure the individual buttons as desired.
For example, you could configure the right-hand group of eight
buttons for Level selection.
See Figure 162.
d. When finished configuring, select Save to save the configuration
changes.
3. Configure the 48B panel:
a. Go to Encore Panels > 48B > Select. Select the 48B panel that will be the
Expansion unit.
b. Go to Configure 48B Flags > Panel Group Name. This will display the
“Panel Groups names list.” Select the name of the XY panel that will
be the main unit.
c. Configure the individual buttons as desired.
For example, you could configure the top row of 32 buttons for
Source selection and the bottom row of 32 button for Destination
selection. In this case, selecting a Destination on the 48B would
allow control of that output from both the XY and 48B (
Figure 162).
Status
Preset
Level
Dest
ID
Chop
SrSrc
CE
Clear
SalvoSalvo
PrevPrev
LevelLevel
Next
Prot
Take
Outputs 1-24
Levels 1-8
Inputs 1-24
XY Master
48B Expansion