Service manual

Encore — Configuration Manual 245
Configuring Encore Control Panels
Figure 145. Destination Exclusion Set Pane
Destination Exclusion Set Configuration Menu
The Named Sets list box on the left side of the screen shows all the Destina-
tion Exclusion Sets configured in the CP Server. When the CP Server starts
up for the first time, only the Default Exclusion Set appears. The Default
Exclusion Set cannot be edited. The selected Destination Exclusion Set is
highlighted in red. The Panel configuration or Template currently being
edited will use the selected Destination Exclusion Set.
The Available Dst list box in the center shows the Destinations which are not
excluded in the currently selected Area and the
Inhibited Dst list box on the
right shows the Destinations which are inhibited in the currently selected
area.When a panel is configured to use this Exclusion Set the Destinations
appearing under the
Inhibited Dst list cannot be controlled from that panel. If
a list box has more than twelve entries, the Up and Down arrows below the
box are activated for scrolling that list.
The Available and Inhibited Destination lists can show Destinations per-
taining to only one Area at a time. However, a Destination Exclusion Set
may exclude Destinations from any or all defined Areas. You will first need
to choose the Area before you can exclude Destinations in those Areas.
Clicking on the
Area button above these two lists opens a list of available
Areas. The Home area of the CP Server is chosen by default.