Service manual

Encore — Configuration Manual 237
Panel Configuration Screen Description
Keypad Search
Filter
When ON, allows the keypad entered preset names to be
searched for exact root name matches and scroll through
only matching root name Sources. This feature can also be
assigned to a panel button to toggle it on or off directly on
the control panel.
(Right Column)
(Green indicator light = enabled
No indicator light = disabled)
Level Change
Lock
When ON, prevents a panel from initiating a break-away.
Note, however that a Source will automatically cause a
breakaway if defined with fewer Levels than its routed
Destination.
Level Display
Toggle
Available on Encore XY and UCP panels, and the SMS
UCP panel. When ON, the panel will report the active
Destination in the Level display when the panel is in
Source mode, Auto Tally is enabled, and no Source name,
prefix, or suffix has been preset.
Level Inverse
Lock
When ON, the Level Invert feature is disabled.
Lock/Protect
Override
Typically this is left OFF because this flag creates a “super
user” control panel. When ON, allows the panel to change
the Sources for Destinations that are Locked or Protected
by another device in the system.
IMPORTANT NOTE - For Encore 1.8 and higher software
this flag allows Salvos executed by this panel to override
Locked or Protected Destinations. In earlier software ver
-
sions Salvos did not override.
Monitor Control
When ON, allows the panel to control system Output
Monitors configured by the
Dst Monitor/Page parameter.
Monitor Control Takes the control panel's controlled Des
-
tination(s) to the Output Monitor that is typically used for
quality control.
Monitor Only
When ON, allows only Output Monitor control from the
control panel, preventing the panel from making any
other crosspoint changes. This feature is typically used for
quality control stations.
Multiple Dst
Control
When ON, Control Panel Partitioning is activated for that
panel. See
Control Panel Partitioning on page 269 for more
information.
Preset Swap
When ON, swaps the existing active Source of the con-
trolled Destination to the preset Source following a Take.
This allows a simple and quick Undo Take capability.