Service manual

Encore — Configuration Manual 233
Panel Configuration Screen Description
Low Tally Bright
Specifies the brightness of panel button low tally display
within a range from 1 to 9. 1 is dimmest, 9 is brightest.
This feature is intended for special conditions and is
slightly brighter than backlighting. For users not desiring
the flashing LED indication, the Low Tally feature is used
to denote special conditions such as breakaway Levels or
ownership of a Destination Lock/Protect. This feature is
not available in legacy SMS7000 control panels.
Note that the actual low tally illumination of a panel
button cannot be lower than backlight brightness, even if
the low tally setting is given a lower value.
Dst Monitor/Page
Opens a menu for configuring the panel's controllable
monitor(s) as well as a QC Destination. Configuring a QC
Destination allows users to select the Monitor Only flag
which disables all crosspoint change capability from the
panel except when the panel is actively controlling the
defined QC Destination. This is feature is typically used
for quality control monitor stations to prevent unwanted
crosspoint changes by a quality control operator. This
feature requires that the Monitor flag be enabled.
Default Dst/Page
Opens a menu to configure the panel's default Destina-
tion(s).
Default Tally Lvl
Because a panel's controlled Destination can have mul-
tiple Levels, the user must define which Levels report the
status. The default tally Level is used to define the initial
Level the panel will tally status on. All panels can also
dynamically change which Level the panel tallies, via
button presses on the control panel.
Dst Page Set
Available only on panels that can control multiple Desti-
nations at the same time. Opens a menu used to configure
multiple Pages of Destinations that the panel can access
using Destination Page mode. See
Page Set Configuration
Menu on page 246 for more information.
Svo Page Set
Available only on panels that can control multiple Desti-
nations at the same time. Opens a menu used to configure
multiple Pages of Salvos for quick Salvo access. See
Page
Set Configuration Menu on page 246 for more information.
Src Category Set
Allows limiting a Control Panel’s access to only specific
Sources. See
Source Categories on page 251 for more infor-
mation.