Service manual

226 Encore — Configuration Manual
Section 6 — Control Panel Configuration
Panel Template Management Window
Figure 138. The Panel Template Management Window
The controls in the left pane are for templates.
Templates list
window
Uses a scrollable list window to display all of the tem-
plates available for the selected type of panel. Only tem-
plates appropriate for the type of panel you’ve selected
are displayed in this list.
Edit
Loads the template selected in the Templates list window
into the application for editing.
Rename
Opens a window where you can rename the template
selected in the Templates list window. You cannot rename
the factory
Default template. The template name can be
up to eight characters in length. Avoid leading spaces,
angle brackets (< >) on either end of the template name,
and trailing pound signs (#).
Set As Default
Sets the template you have selected in the Templates list
window as the default template for that type of panel. The
template designated as the default will be automatically
assigned to any new panels of that type (for example, 48B,
BPS, PMB, or XY) installed in the system until a different
template is copied to the panel(s). If any template other
than the factory Default is designated as the default tem
-
plate, a chevron sign (>>) will be placed in front of that
template name in the Templates list window to designate
its status.