Service manual

Encore — Configuration Manual 203
Concerto Port Matrix One-to-Many Control
2. Go to Config, Physical Matrix, choose the Crosspoint Group being used for
the Concerto Port Router, then click on
Matrix Type, and choose Concerto
Port Multi Drop Router
(Figure 128).
Figure 128. Matrix Type for Multi Drop Concerto Port Router
3. If you are not already using one-to one Concerto Port routing, you will
also need to define the rest of the Port Router configuration parameters
on this menu.
4. You will also need to go to Config, Source, and Config, Destination and define
Sources and Destination of the port routed devices to use connectors on
that Multi Data level. Both the Source and Destination for each device
need to be defined to use the same connector since bi-directional
communications is used for the first controlled device.
Note If you wish to have device control follow video routing, define these data
Sources and Destinations as an additional Level for the device’s video
Sources and Destinations.
5. Finally, you will need a Control Panel able to do multi destination
routing (an Encore 48B, for example) configured with access to the
various devices’ Sources and Destinations.
Refer to the separate Concerto Configuration Manual for more detailed con-
figuration information.