Service manual

Encore — Configuration Manual 197
Native Protocol Matrix Driver
7. Specify the Address as the Level that exists on the remote system, for
which the Source(s)/Destination(s) are to be controlled (
Figure 123).
This field accepts hexadecimal values only. If we want to control the
Sources and Destinations on Level 10 of the Remote System then we
need to enter ‘a’ as the address. Values of 0 and FF are used to indicate
all Levels.
Figure 123. NP Matrix Configuration, RCE Address
8. In the Net Name field specify the IP address of the NATIVE CONTROL
system (SMS7000/Encore).
Matrix size differences between the SMS7000 (remote) and the Encore
RCE must be accounted for in the configuration. In order to ensure
matrix size matching is sufficient, it is recommended that users con
-
figure the Encore RCE physical matrix and segment size to be 1024
maximum size. Users must be careful to ensure that only the matrix and
segment sizes are increased and not the number of Sources and Desti
-
nations.