Service manual

186 Encore — Configuration Manual
Section 5 — Router Configuration
Figure 112. Router with single monitor output (e.g. Concerto).
In this example, the control panel’s Destination output 2 is connected to the
output monitor; consequently switching input 1 to output 2 will display
input 1 on both output 2 and the monitor output.
Note If a crosspoint board that has a currently monitored Destination is removed
from its frame, that Destination monitor will not be restored when the cros
-
spoint board put back in. You will need to perform a monitor Take after the
board is reinserted.
To Configure and Use Destination Monitors
1. Using the Router Control application’s System Configure screen set the
maximum Sources and Destinations to be configured. To configure
Destination Monitor(s) increase the number of Destinations by the
number of Destination Monitors to be configured. See
Figure 113.
QC STATION
Router
23
4
1
5
1
2
3
4
6
7
8
n
n
Router inputs
Router
outputs
Monitor output
Internal monitor
switcher
5
Encore Control System