Service manual

Encore — Configuration Manual 183
Database Validation
Database Validity Indicators
The Validate DB button has three states:
• Normal - Uncolored background: Indicates the database has no discrep-
ancies in the configured Source and Destination configuration.
• Warning - Yellow background: Indicates minor inconsistencies are
present in the configuration. For example, a particular Source or Desti
-
nation may not have a valid connector.
• Invalid - Red background: Indicates the database has serious inconsisten-
cies within the internal data and references. In this state it is recom-
mended to take action to resolve the situation (see Invalid Router
Database Resolution below).
Invalid Router Database Restrictions
When the router configuration is invalid the following actions are not
allowed.
• Increasing the start input and start output of the segment(s) in the Phys-
ical Matrix screen.
• Decreasing the end input and the end output of the segment(s) in the
Physical Matrix screen.
• Adding or deleting elements in the Logical Matrix screen.
• Changing I/O connector or Level Mapping in the Sources and Destina-
tions screens.
Invalid Router Database Resolution
1. Take the Router Controller offline.
2. Click on the Validate DB button. The Router Controller will regenerate its
internal references and display the Sources and Destinations lacking
proper connector numbers.
You can click on a listed Source or Destination to go directly to the
Source/Destination screen and make a correction.
Note If more than 100 Sources or Destinations have invalid connector numbers,
only the first 100 will be displayed.
3. The Validate DB button may turn Yellow at this time if the Router
Controller was able to regenerate all its internal references.