Service manual

176 Encore — Configuration Manual
Section 5 — Router Configuration
4. Use the small indicator buttons in the Levels Area to check if a Level is
currently routed to a Destination for the selected Source. A green
indicator signifies that the Level is routed for the selected Source, and a
red indicator signifies that a different Source is routed to the
Destination on this particular Level. Clicking on the small button when
the indicator is red shows the name of the Source currently routed on
this Level (this is shown below the
Select Source text).
5. Click on the EXECUTE button to make the Take.
Note The Hold Source button (when it is green) allows the user to hold the cur-
rently selected Source when a new Destination is selected. This feature
enables the same Source to be taken to a number of different Destinations
very quickly.
Router Status Screen
The Router Status Screen (Figure 109) shows the status of each Destination
configured in the Router Control application. Arrow buttons are situated
near the bottom of the screen to allow the user to scroll through the infor
-
mation.
Figure 109. Router Status Screen
(Dest column)
Fixed column which is always visible in this screen and
lists Destinations by name.