Service manual

Encore — Configuration Manual 175
Route Screen Description
Making a Take
1. Click on the button directly below the Select Destination text and
choose a Destination from the list window. The selected Destination is
then shown on the button.
2. Click on the button directly below the Select Source text and choose a
Source from the list window. The selected Source is then shown on the
button.
3. In the Levels Area on the right of the screen, select the Levels that you
want to Take by clicking on the long indicator buttons (i.e., the buttons
that show the names of the Levels). Use the arrow buttons if necessary
to scroll down to reveal more Levels. A green indicator signifies that a
Level is selected, and a red indicator signifies that a Level is not
selected.
Note A Destination must be selected prior to selecting the Levels to route, even if
this means re-selecting a Destination. If a Take is executed, Levels are
changed, and the same Take is executed again, the new Levels will not be
taken.
Hold Source
When this button is green and a new Destination is
selected, the Source is ‘held’ from the previous Take
instead of the Source that is currently connected to the
new Destination from being displayed. This feature
enables many Takes that all use the same Source to be
made quickly.
Chop
Permits Chopping between two sources. Click on the Chop
button, then select a different Source and click on
Execute.
The Chopping status will be reported.
Hold indicator
When the indicator is green, the selected Levels in the
Levels Area remain fixed for the next Take.
Track indicator
When the indicator is green, the current Levels (and the
Sources supplying these Levels) are automatically
selected when the next Take after the current Take has
been executed.
Level n indicator
These buttons are used to specify the Level(s) to be used
in a particular Take.
Up Down Arrows
Pages up or down one screen of Levels per click.
Displays the Router Status Screen.