Service manual

154 Encore — Configuration Manual
Section 5 — Router Configuration
Two Elements in Two Crosspoint Groups (Separate I/O)
This example is for one Level (Audio Stereo) containing two elements
(Audio Left and Right) which is mapped into two Crosspoint Groups using
independent serial communications.
Figure 94. Two Elements in Two Crosspoint Groups (Separate I/O)
In this example the Audio Left element has connector IDs 1 – 32, and Audio
Right also have connector IDs 1 - 32. A Source or Destination using this
Level has the connector ID configured for the first Level (Audio Left) and
the Audio Right connector automatically uses the same connector ID in the
second Crosspoint Group.
Table 13. Configuration for Two Elements in Two Crosspoint Groups (Separate I/O)
Crosspoint Group
Matrix Controllers
within Crosspoint
Group
Segments within Crosspoint Group Logical Matrix
Name Max Input Max Output Matrix Controllers Segments Matrix Controller I/O Channel
a
a
S = Same for both crosspoint groups; D = Different for each crosspoint group; A = Any channel.
Address
a
Outputs ID Input range Output range Type & Factor Unique Name Level Inter levels Elements
Audio_L_phys 32 32 1 1 1
D A
Xpt
Group
L 1-32 1-32 Block Yes
Audio_Stereo
Audio
Stereo
None 2
Audio_R_phys 32 32 1 1 1
Xpt
Group
R 1-32 1-32 Block Yes
Crosspoint Group
132
32
L
132
32
R
I/O ChannelsLogical Matrices
Audio_Stereo
32x32 Matrix
Connector ID 1-32
Two Elements