Service manual

152 Encore — Configuration Manual
Section 5 — Router Configuration
Two Elements in One Blocked Crosspoint Group
This example is for one Level (Audio Stereo) containing two elements
(Audio Left and Audio Right) which is mapped into one Crosspoint Group.
Figure 92. Two Elements in One Blocked Crosspoint Group
In this example the Audio Left element has connector IDs 1 – 32, and Audio
Right has connector IDs 33 – 64. A Source or Destination using this Level
has the connector ID configured for the first Level (Audio Left) and the
Audio Right connector is calculated by adding 32.
Table 11. Configuration for Two Elements in One Blocked Crosspoint Group
Crosspoint Group
Matrix Controllers
within Crosspoint
Group
Segments within Crosspoint Group Logical Matrix
Name Max Input Max Output Matrix Controllers Segments Matrix Controller I/O Channel
a
a
S = Same for both crosspoint groups; D = Different for each crosspoint group; A = Any channel.
Address
a
Outputs ID Input range Output range Type & Factor Unique Name Level Inter levels Elements
Audio_phys 64 64 1 2 1 A A
Xpt
Group
L 1-32 1-32 Block Yes
Audio_Stereo
Audio
Stereo
None 2
R 33-64 33-64 Block Yes
Crosspoint GroupI/O ChannelsLogical Matrices
Audio_Stereo
32x32 Matrix
Connector ID 1-32
Two Elements
132
32
64
64
L
R