Service manual

150 Encore — Configuration Manual
Section 5 — Router Configuration
Two Levels in Two Crosspoint Groups (Separate I/O)
This example is for two audio Levels (Audio Left and Audio Right)
mapped into separate Crosspoint Groups using separate serial communi
-
cation channels. The Router Controller cannot carry out inter-level routing
as the Crosspoint Group is not common.
Figure 90. Two Levels in Two Crosspoint Groups (Separate I.O)
Table 9. Configuration for Two Levels in Two Crosspoint Groups (Separate I.O)
Crosspoint Group
Matrix Controllers
within Crosspoint
Group
Segments within Crosspoint Group Logical Matrix
Name Max Input Max Output Matrix Controllers Segments Matrix Controller I/O Channel
a
a
S = Same for both crosspoint groups; D = Different for each crosspoint group; A = Any channel.
Address
a
Outputs ID Input range Output range Type & Factor Unique Name Level Inter levels Elements
Audio_L_phys 32 32 1 1 1
D A
Xpt
Group
L 1-32 1-32 Block Yes Audio_Left
Audio
Left
None 1
Audio_R_phys 32 32 1 1 1
Xpt
Group
R 1-32 1-32 Block Yes Audio_Right
Audio
Right
None 1
Crosspoint Group
132
32
L
132
32
R
I/O ChannelsLogical Matrices
Audio_Left
32x32 Matrix
Connector ID 1-32
Blocked Format
Audio_Right
32x32 Matrix
Connector ID 1-32
Blocked Format