Service manual

Encore — Configuration Manual 145
Router Controller Configuration Save and Load
5. Repeat Step 4 until all Sources are displaying Available or Inhibited as
required. Use the arrow keys if necessary to scroll through the list of
Sources.
Note The Inhibit All button on the Menu bar provides a quick method of setting the
status of all the Sources to Inhibited. The Allow All button on the Menu bar
provides a quick method of setting the status of all Sources to Available.
6. Click the Add button in the Destinations section of the screen to select the
Destinations to which this rule will apply.
Sources with the Inhibited status will not be able to be routed to these
Destinations.
7. Click the List button to see the list of Destinations to which the rule will
apply.
8. If necessary add more Destinations to the list by clicking the Add button
again, or remove Destinations from the list by clicking on the
Remove
button.
9. When you’re done, click the Config. button on the Main menu.
10. When you arrive at the System Configure screen, click the Obey Rules
button in the Options portion of the screen to enable your configuration
to abide by any rules you’ve defined here and will apply in the
Destination Configure screen.
11. Click the Save button and then the Commit Changes button.
You may now apply and use your rule(s).
Router Controller Configuration Save and Load
The Router Controller allows multiple configurations to be saved in the
Sharer database and easily reloaded by selecting the desired configuration
name from the list of saved configurations.
The procedures earlier in this section gave instructions on saving the
Router configuration and updating the network with these changes as they
were made. The following generic procedure describes how to save and
load Router configurations at any time.
Saving Router Configurations
Saving with a New Name
1. From the Router Controller Main screen (Figure 66 on page 104), press
the Save As button.