Service manual

142 Encore — Configuration Manual
Section 5 — Router Configuration
59. Click in the Type column to toggle between Physical and Virtual
definitions for the matrix listed on the same row in the Name column.
60. Click in the I/O column next to the same Level used in Step 58 and enter
a number that maps to the physical connector ID for the Destination on
the router matrix for that Level.
61. Repeat Step 58 through Step 60 until all necessary Levels for the
Destination are configured.
A green indicator next to the name of a Level in the Levels Area confirms
that the Level will be routed to the currently selected Destination.
A yellow light indicates that attributes are available for a Level.
And a red light indicates that the crosspoint is invalid. Check the matrix
configuration for errors and, once corrected, click the
Config. button on
the Main menu to return to the System Configure screen and click the
Re-Sync Comms button.
The buttons on the menu bar on the right of the screen aid the configuration
process.
• Use the Select Dst. button to amend a previously configured Destination.
The list window that appears on the screen allows a selection to be
made by name or number.
Figure 84. Select Destination Window
•Use the New Dst button to select the first Destination number in the
router database that does not have a name assigned to it.
• Click the Rules button to open the Rules Configuration screen. See Rules
Configuration Screen on page 143 for more details.