Service manual

140 Encore — Configuration Manual
Section 5 — Router Configuration
Configuring a Destination
The following procedures continue from Configuring a Source on page 135,
but can be used to configure Destinations at any time.
52. Click the Destination button on the Main menu to go to the Destination
Configure screen.
53. Click the Dest. button and specify the number of the new Destination.
This number represents the logical number of the Destination in the
router database.
54. Click the ID button to give the Destination a unique identity (maximum
8 characters).
This can be regarded as a short form name for the Destination and is
displayed on the control panels and the Local Router Panel.
55. Click the Name button to give the Destination a longer, more meaningful
name (maximum 16 characters).
This can be regarded as a long form name for the Destination.
56. Click the Type button to choose the hardware type of the Destination
from the list window that appears on the screen.
Copy &
Inc(rement)
Adds the next consecutive Destination number (from that
currently shown on screen), with the ID and name incre
-
mented by 1. For example, suppose the current
Destination is Destination 24, with ID “Mon1” and name
“Monitor1”. Clicking the
Copy & Inc button will create Des-
tination 25, with ID “Mon2” and name “Monitor2”.
Multi New
Allows the automatic creation of multiple Destinations,
similar to Copy & Inc, except the number of items to be
created is specified and then created with one button
press.