Service manual

Encore — Configuration Manual 127
Physical Matrix Screen Description
21. In the Controller section of the screen, ensure that you have the
appropriate controller selected.
If you specified one controller in the No. Controllers field of the Cross
Point Group section of the screen, you will have only one controller to
choose from. Otherwise the controller list, accessed by clicking the
Select button in this section, will contain the same number of controllers
you specified in the
No. Controllers field of the Cross Point Group section
of the screen.
22. Click the Channel button to choose the channel you previously defined
to communicate with this controller.
Once you choose this channel, the read-only Protocol field will display
the protocol associated with it during the channel definition process.
23. Click in the Address field to type the address you want to use for this
controller. If you’re configuring a Grass Valley Group product, type
0
(zero), since we do not use this.
This field is protocol dependent, check user documentation for the
product you’re configuring.
24. In the Outputs field type the number of outputs for this controller.
25. If the Hardware Lock button is available (depends on the protocol and
matrix), toggle it on or off to enable/disable hardware locking.
See on page 119 for an explanation of this feature.
26. If the channel you're defining uses an ethernet-based protocol (such as
GVG CPL) which requires an IP address to enable control of the matrix,
type the matrix IP address (recommended) or DNS name in the
Net Name
field.
Otherwise the field is uneditable and indicates
N/A (Not Applicable).
27. If you’re using a non-digital video Concerto matrix, click the Controller
Attributes
button to open the Attribute Configuration screen, and then
confirm or modify attributes for the Concerto’s board slots as needed.
28. If you need to add a controller in a specific order in the controller list,
use the
Insert before or Insert after buttons to add the new controller before
or after the one displayed in the
Controller No field of the Controller
section of this window.
Note To see the existing list and order of controllers, click the Select button in the
Controller section of the screen to see the Controller Select list window.
29. Change any settings necessary in the Segment section of the screen.
In the Segment section of the Physical Matrix Configuration screen
some of the settings are inherited from those you made in the Cross