Service manual
126 Encore — Configuration Manual
Section 5 — Router Configuration
Configuring a Physical Matrix
The following procedures continue from Configuring a Communication
Channel on page 115, but can be used to configure a Physical Matrix at any
time.
Note See Sample Router Configurations on page 148 for examples of several con-
figurations of Physical and Logical Matrices, Segments, and Elements.
13. Click the Phys Matrix button on the System Configure Main menu.
14. Use the Select button in the CrossPoint Group section of the screen to
choose an undefined Crosspoint Group (~Undef Xpt Group n).
15. Click in the Name field and type a more meaningful name, for example,
Washington SD.
16. Click in the No. Inputs field and type the number of inputs.
This entry is copied into the Last Input field in the Segment section of the
screen because the default configuration is one Segment in the Cros
-
spoint Group that is the same size as the whole Crosspoint Group.
17. Click the No. Outputs field and type the number of outputs.
This entry is copied into the Last Output field in the Segment section of
the screen because the default configuration is one Segment in the Cros
-
spoint Group that is the same size as the whole Crosspoint Group.
18. In the No. Controllers field, indicate the number of controllers used in this
Crosspoint Group.
The controller limit is 32. An entry for each controller will appear in the
Controller Select list window when you click the
Select button in the
Controller section of the screen.
19. In the No. Segments field, indicate the number of Segments for this
configuration.
The limit is eight. If you indicate more than one Segment, follow these
procedures through
Step 29, then proceed to To Configure Additional Seg-
ments on page 128.
20. If you’re using Grass Valley Group’s CPL, click the Matrix Type button
and choose the desired matrix type from the list window which
appears. Otherwise you can skip this step.
Select Connector
Allows selection of a connector number by scrolling
through a list or specifying a connector number.
Up Down Arrows
Pages up or down one page per click.