Service manual

118 Encore — Configuration Manual
Section 5 — Router Configuration
Matrix Type
Allows the type of matrix to be chosen from a list and dis-
played for a particular Crosspoint Group.
Note that this setting is required only when using Grass
Valley Group’s CPL protocol.
Global Attributes
Retrieves global attributes for the first controller in the
Crosspoint Group. It is assumed that all others have the
same attributes.
Delete Group
Resets the Crosspoint Group displayed in the (Cros-
spoint) Name field, removing its associated settings (e.g.
controller and Segment) and freeing it to be reconfigured
and reused.
No. Monitors
Allows the maximum number of monitors to be defined
for a particular Crosspoint Group.
Controller No.
Displays the ID number of the selected controller for the
Crosspoint Group displayed in the (Crosspoint)
Name
field. (Large Crosspoint Groups may use multiple con-
trollers.)
Channel
Allows a communication channel to be chosen by name
from a list of those previously defined in the I/O Channel
Configuration screen. The channel selected here displays
the protocol it uses in the
Protocol field of this screen.
Address
This field is device dependent and therefore only appro-
priate for certain protocols. In those cases it allows the
address for the specified controller to be defined.
Protocol
Displays the protocol associated with the selected
channel. Cannot be edited here; must be changed in the
Channels Configuration screen.