Service manual

114 Encore — Configuration Manual
Section 5 — Router Configuration
Reset
Selects the first (top-most) entry in the list.
Select
Enables a communication channel to be selected from a
list window displaying both channel index numbers and
their selected protocols.
Initialize Channel
Initializes the communications channel displayed in the
Channel Index field. To finalize the settings, this button must
be clicked after the channel and channel parameters are
set.
Delete Channel
Resets the channel displayed in the Channel Index field,
removing its associated protocol and channel parameters
and freeing it to be reconfigured and reused. This button
has global and permanent implications, at least until the
system is reconfigured.
Protocol
Allows a protocol (See Figure 72.) to be selected for a par-
ticular communication channel for specific devices. Your
choice here will also fill in the default I/O Channel
Parameters for that protocol and dictate which buttons
you see beneath it. For example, selecting the
GVG CPL pro-
tocol (used for Ethernet communications with Grass
Valley matrices) will display only an IP Address button in
the I/O Channel Parameters group
.
Figure 72. Select Router Protocol List
Port
Allows one of eight serial ports on the Device Control
Engine to be specified for a particular communication
channel. This button is only visible for serial protocols.
Baud Rate
Specifies the baud rate for a particular channel. Clicking
on the button allows the value to be changed.