Installation guide

VSR-1200™ and RDU™ Installation and Quick Configuration Guide Page 7
c If the item requests additional information, enter that information.
❖ When the item has been configured, the scenario’s menu is displayed again.
5 After you have performed Step 4 for each item (parameter) in the menu, do one of the
following:
a Select Load Above Config.
❖ The following prompt asks for confirmation. Go to Step 6.
b Select Reset (Load, Write and Reset).
❖ The following prompt asks for confirmation. Go to Step 6.
c Select Clear All Fields.
❖ The following prompt asks for confirmation.
• Do one of the following:
◆ If you wish to reconfigure, enter Y.
❖ All fields in the menu are reset to null values. Return to Step 4.
◆ If you do not wish to reconfigure, press Escape to return to the Startup
Configuration Scenarios menu.
❖ The configuration retains the settings you have entered, but they are not yet in use.
Return to Step 4.
6 To load the new configuration, enter y.
❖ The configuration is loaded into the VSR.
Note: When you write (save) a configuration entered on the Quickstart menu, other
required settings are updated automatically. For example, when you enter the device’s
IP address, a path is automatically set up in the IP routing table to direct this IP
address to the device’s LAN port.
❖ If you selected Reset (Load, Write, and Reset), the configuration is also saved. This
makes the configuration permanent (unless you change it again). Then the device resets.
Caution: Existing configurations will be over written
Do you want to Continue?(Y/N)[N]:
Caution: Existing configurations will be over written
Do you want to Continue?(Y/N)[N]:
This Clears All the above Fields, Continue?(Y/N)[N]: