Installation guide

Page 26 VSR-1200 Hardware Reference Module, Document 2
3 Regardless of screen instructions, do not type anything until you see the banner:
BANDIT, ENCORE NETWORKS INC. Then press Enter.
❖ The Main Menu is displayed.
2.8 Exiting a Session
After the software has been configured, save (write) the configuration. Then exit the session
before disconnecting the PC, so that communication is not disrupted.
Caution: Before you exit, make sure you save (write) the configuration. Otherwise, the
changes you configured will be lost. See Section 2.6, Saving (Writing) the Device’s
Configuration.
To exit the session, do the following:
1 On the Main Menu, select Exit Session.
❖ The following prompt is displayed.
2 Select Yes.
Note: If the configuration has not been saved, the device asks you whether it should
save the new configuration. Answer Yes (or No, if you prefer not to save the
configuration).
❖ The system notifies you that it is ending the session.
Note: To reconnect to the device and start a new session, press Enter.
❖ The terminal’s connection to the BANDIT starts up, and the BANDIT’s Main Menu is
displayed.
Are You Sure? :
Ending Session...
!