Installation guide

VSR-1200™ and RDU™ Installation and Quick Configuration Guide Page 11
b When you have finished configuring the protocol, press Escape to return to the Logical
Port Attribute menu.
2.5.3.2 DHCP Settings
To review settings that the WAN or LAN port uses for DHCP, or to modify or disable DHCP
on a port, do the following on the port’s Logical Port Attribute menu (see Section 2.5.3, Ports).
Note: The WAN and LAN ports use different settings. Typically, a BANDIT device is a
DHCP client on the WAN port and is a DHCP server on the LAN port. You may enable,
modify, or disable use of DHCP on one port or on both ports.
1 Select DHCP Type.
❖ The DHCP Type menu appears.
2 Select the option you want this port to use.
❖ If you select None, the device does not use this port for DHCP. Press Escape until you
return to the port’s Logical Port Attribute menu. Go to Step 5.
❖ If you select Client, the device uses this port to request its IP address. (On the WAN
port, the device requests its public IP address.) No further configuration is required for
the DHCP client role. Press Escape until you return to the port’s Logical Port Attribute
menu. Go to Step 5.
❖ If you select Server, the device uses this port to assign IP addresses. (On the LAN
port, the device assigns private IP addresses.) The Logical Port Attribute menu is
redisplayed, with a menu item for configuring the DHCP server.
3 Select DHCP Server Parameters.
❖ The DHCP Server Parameters menu appears.
DHCP Type
----------
1) Server
2) Client
3) None
Enter Choice :
DHCP SERVER PARAMETERS
----------------------------
1) Local DHCP Server IP Address (N.N.N.N):0.0.0.0
2) DHCP Pool IP Address Low (N.N.N.N) :0.0.0.0
3) DHCP Pool IP Address High (N.N.N.N) :0.0.0.0
4) DHCP Network Mask (N.N.N.N) :255.255.255.0
5) DHCP Lease Time (minutes) : 1440
6) Domain Name for DHCP clients:
7) Primary Router (N.N.N.N) :0.0.0.0
8) NETBIOS Server (N.N.N.N) :0.0.0.0
Enter the number of the item to change: