User's Manual

41
www.encore-usa.com
Destination: Defines the destination of the incoming packet that the rule is applied to.
x Interface: Select which interface (WAN or LAN) the rule is applied to.
x IP Range Start: Type the starting IP address that the rule is applied to.
x IP Range End: Type the ending IP address that the rule is applied to.
x Protocol: Select the protocol (TCP, UDP, or ICMP) of the rule.
x Port Range: Specify the port range.
Bottom Table
x Add: Click to add the rule profile to the table at the bottom of the screen.
x Update: Click to update a saved rule
x Delete: Select a saved rule and click “Delete” to remove the rule from the list.
x Clear: Click “Clear” to erase all saved rules
x Priority Up: Select a saved rule and click “Priority Up” to increase the priority of the
rule.
x Priority Down: Select a saved rule and click “Priority Down” to decrease the priority
of the rule.
x Update Priority: After increasing or decreasing the priority of a rule, click “Update
Priority” to save the changes.