ENHGS-800 GIGABIT 8-PORT ETHERNET SWITCH User Guide 0
FCC Certifications This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
The device is a powerful, high-performance Gigabit Ethernet switch, with all ports capable of 10, 100 or 1000Mbps auto-negotiation operation (NWay), which means the switch could automatically negotiate with the connected partners on the network speed and duplex mode. It is ideal for micro-segmenting large networks into smaller, connected subnets for improved performance, enabling the bandwidth demanding multimedia and imaging applications.
Please refer to the following table for LED definition 5-Port 8-Port LED Status Power Steady Green Off 1000M Steady Green Blinking Green 100M Steady Green Blinking Green 10M Steady Green Blinking Green Operation Power is on Power is off Connected as 1000Mbps The port is transmitting/receiving data. Connected as 100Mbps The port is transmitting/receiving data. Connected as 10Mbps The port is transmitting/receiving data.
Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready. For cable selection, refer to the following table. In making a switch interconnection, you could use any port to connect another switch with straight or crossover cable.
Standard IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3ab 1000BASE-T IEEE 802.3x full duplex operation and flow control Interface 5/ 8* 10/100/1000Mbps RJ-45 Gigabit Ethernet Ports Uplink Auto MDI/MDI-X（Auto crossover） Network Speed 10/100/1000Mbps & Full/Half duplex mode auto detection (1000Mbps for Full duplex only) MAC Addr.
